fbpx

Archive for “Options” Tag

Selecting the Right Starting Position for Olympic Lifts (Part 1)

 

Athletes Options For Olympic Lifts

 

By Wil Fleming

 

Coaches everywhere, and a great percentage of coaches at that, choose to use some type of Olympic lift in their training of athletes. Typically this Olympic lift is a power clean, starting from the floor. While this is appropriate for plenty of athletes, there are multiple variations in the starting position, that it can be hard to determine which is the right place to start.

 

So lets take a look at the advantages and disadvantages of some of the variations in start position.

 

Floor Start Position

 

This is the typical start position and the one used in weightlifting competitions. This position is the one that as coaches we see high school athletes using most often in their high school training program.

 

In this position the athlete starts with the bar at rest on the floor, and the bar should be close (~1-2 inches) from the shins. Athletes starting in this position should slowly, and under control lift the from the floor, ultimately passing the knees.

 

Pros: This position is the position from which the most weight has ever been cleaned or snatched, has been lifted. This is due to the momentum gained from the correct pull off the floor. Using the floor start position requires the athlete to increase hip range of motion due to the low starting position.

 

Cons: This position requires great hip mobility, and therefore, if an athlete is lacking in hip mobility they will typically gain this lower start position through an increase in lumbar flexion. Lumbar flexion with loads in front of the spine have been attributed to greater shear forces on the spine and a corresponding higher incidence of back injury. The typical floor start position also requires athletes to move the bar by the knees. This area of movement is one that requires great technique and for many athletes means that their technical problems occur in this area. More lifts are missed due to the first pull moving around the knee than in any other area of the lift. Poor lifts will have an S pull where the bar will move forward to travel pass the knee.

 

Block Start Position

 

The block start position is used often in the technical training of competition weightlifters.

 

The actual start position can be adjusted in height to meet the goals of the training session, but typically the athlete will start from a static stance somewhere above the knee.

 

Pros: Block starts are a great teaching tool. Coaches can specify the exact starting position that the athlete must achieve. This position is usually close to the 2nd pull (the rapid acceleration of the bar), and requires very little thought from the athlete once the bar is in place. Cueing the pull from a block position is fairly easy for the coach, typically aggressiveness and explosiveness are the only thing needed. The block start position is great for starting strength, no momentum is used and the stretch shortening cycle is eliminated. Starting strength is great quality to develop for nearly any athlete.

 

Cons: Situating the athlete in the correct start position can be hard for the uninitiated coach, differing starting heights require differing positions that are sometimes very dissimilar. Blocks can also be expensive to purchase or difficult to assemble, and therefore many weight rooms or facilities do not allow for the possibility of coaching athletes from a block starting position.

 

There are even more possibilities for Olympic lift start positions stay tuned for Part 2 to learn about 2 of my favorite start positions for young athletes.

 

 

olymic lifts young athletes
Learn More the Olympic Lift Instructor Course Today!

 

olympic-lifts